Answer Posted / senthil473

basically column is a compression member. maximum compression load sustained by column and transferred to foundation through the axis of the column. steel is not good in compression. because of lateral loads and eccentric loads the tensile stress created only around the center but not up to the center. because of that only around center reinforcement is enough to take care of the tensile stress.

Which is the most prominent tower of world?

1033

---

how to find hardness of water?why it should be determined?

2029

---

Hi all, please guide me about the volume. And percentage. Of steel fibre to be used. My project. Is Sifcon.

2169

---

please send latest placement papers of hpcl officers trainee test. i will be very thankful to you.

2247

---

How to take labor charges for construction of 1cum of concrete?

1119

---

what motivates you to do a good job

3115

---

from where ican get sample papers for CET-delhi 2012

2438

---

how do i remedy a foundatiom that the column bases was cast and aftet 28days crushing the conprehensive strength of the concrete fall below the specification 25N/mm2

1918

---

Prepare a Schedule for a Highrised building from starting stage to Handover?

1941

---

How do you convert wind speed into force?

1250

---

How many pyramid in egypt?

999

---

what is hydrostatic paradox?

2197

---

how to calculate the scour depth

2841

---

i have to give lap joint fo 1Mtr steel of dia12mm,whenever i did mistake i cut less 5cm plz tell me how much i will give lap joint so that length comes 1Mtr

1957

---

Hi how r u ? hope you are fine there . Please can u tell me tha Design life of Buildings as Per ACI CODE 318-99. It will be a pleasure for me .Thanks in advance

2496

---