Hello friends i need check lists of different instruments
during the Erection and commissioning in thermal power
plant.Please help me.My Mail id is
naba02222@gmail.com/naba02222@rediffmail.com
Thanks
Nabakishore Biswal
- 1 Answers
- 3392 Views
- I also Faced
- E-Mail Answers
Answer Posted / jeff hawley
Call MMR ProCom at US ( 832-237-9800) and ask for Job assistance with specific device(s) information and quanities and we would be happy to help you
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How to measure the dust in chimney(spm)?
field bus transmitter calibration procedure tell me
The Design Calculation of Level Transmitter For Different Structure open & Closed Vessel, Eg. Diff. Level Tx., Capacitance For Continous Operation
the 3 most common transmitter protocol being in refinery or qatar gas and aramco.
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
how to connect transmitter measuring sulfur process? 1-by using long impulse line or 2- by using coated short impulse line
how to calibrate load cell
I want to apply for the universities in US,but i got the GRE score of (650+300=950)TOEFL 69/120.Is this score sufficient for applying universities please i am married i need to go to US because my husband didn't get H1 yet.please send me suggestion
What care will you take in the installation of control valves,SCADA,DCS and FOC in Oil and Gas Project?
Calibration procedure for Electro magnetic Flow meter
hello sir/madam, I,Subramanian need 5yrs placement papers of officer trainee of Instrumentation technology.pls send to this mail id mani_nxtgen@yahoo.co.in please do the needful. with regards, subramanian.v
State some of balance principle’ advantages?
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
If i have 4 Allen Bradely make RS logix 5000 PLC and for viewing that we are using 4 RS view SCADA for 4 different packages. Now, I will want to view two packages on only one SCADA. Then how i will do it?
