Interested to Buy Any Domain ? << Click Here >> for more details...
Steve said that "An eddy-current probe works by passing an alternating
current through a coil of wire and measuring the coil’s
impedance" while we are using -24 Volt DC , So I am confused about DC and AC. Plz .
- 2 Answers
- 3550 Views
- Jindal, Sadara Chemicals, I also Faced
- E-Mail Answers
Answer Posted / niraj
We are giving 24V DC to Vibration probe is having driver circuitry which will generate AC signal for eddy current
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Explain PID, ON/OFF, Controls
Why humidity limit is 30 to 55 % for raw material storage?
How to control flow variations in magnetic flow maters..... When i will provide proper earthing?
Tell about your IFFCO plant visit.
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
What is the exact differences between HART,FOUNDATION FIELDBUS,PROFIBUS?
Explain the working of rota meter.
Why we are using reverse action in displacer types level transmitters on some Vessels?
please tel me the calibration of pneumatic controler.
NPN transistor, SCR, Zener diode, LED, Varactor diode, Vortex meter, RTD, Resistor, Crystal
what about your moleg in pogrees with company
in mass flow meter what is drive friquancy ?
Why use ball valves on Gas pipelines instead of gate & or globe valves...means basic diffrence or use of these valves..how designers knows this type of valve with rating is required...
How is PH sensor works ?
I faced several time siemens ps2 positioner automatically getting Chang in it's set point direction after auto calibration So is there any causes biside this or any permissives ?
