Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rakesh bawankar
force balance principle
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Explain why use mmwc unit?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
how to measure draft pressure in transmitter pl. give its single line digram
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
What are different types of orifice plates?
i am from instrument branch i want paper patern of mahagenco . any pevious years paper regarding my branch send me please . please.....
how to connect transmitter measuring sulfur process? 1-by using long impulse line or 2- by using coated short impulse line
What is exact difference between the panel earthing and system earthing in DCS system. What is the value of resistence.
How to convert mmWc(mili meter water colam) to tph(ton per hour)?
What is cut off relay? And why use in PLC and DCS?
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
how do we commission inergen system?
Specify for Cables - Flame Retardant and Fire Resistant?
how many type of plug are used in pneumatic control valve,name them.
please send me the inteview questions in IOCL
