Interested to Buy Any Domain ? << Click Here >> for more details...
What do you need to consider when installing a flowmeter
- 2 Answers
- 3931 Views
- I also Faced
- E-Mail Answers
Answer Posted / rakesh bawankar
Its about installation so we have to check direction of flow first them upstream and down stream length of pipe .
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
which type inter lock use in petrochemical refinery,and oil & gas?
Displace type LT to be calibrated in workshop, wt. 40, dia- 60 mm, density- 0.8kg/cm3.
How to calibrate radar type level transmitter for interface level? Total liquid(liq.1 and liq.2), level both the liq individually? For. Both the liquid levels how the signal will go from transmitter to dcs? How to calibrate. Single radar 9:26:55 AM for 2 different liquids in a tank?
What is the use of single seated valve?
i have done DAE in Instrumentation and Process Control. i have applied for an apprentice training in chemical company after three day my interview will be conduct but i need more information about industrial process control and controller. my e mail is imran_dilsetu@yahoo.com please tell me interview question relative to instrumentation ?
why we use 3 wire rtd direct wiring for temperature measurement instead of temperature transmitter like bearing temperature
What are primary elements of measuring pressure?
What pressure results for a flow transmitter of range 0- 180t/h in the dcs and 0-301mbar in the field using square root extraction. Kindly also suggest formulae for the percentages 0,25,50,75,100?
Please tell me details about Sox,Nox,SWAS analyser????
what are the diff. in servo and regulatory control?
Isometric drawings are generated during _________________ phase of a project
what is the input to be given in digital flow meter during the the calibration time?
What is the exact differences between HART,FOUNDATION FIELDBUS,PROFIBUS?
Explain an adaptive / self-tuning controller’s major draw card.
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
