Answer Posted / subhansab b
We know ratings always depends upon temperature. But temperature always depends on the losses..
We know transformer having only two losses that is core losses and copper losses... we know core losses also known as constant losses because it depends upon voltage and cu losses also known as variable losses because of it depends upon load current...from these two losses we only knows current and voltage.. so we are using VA rating.. For large transformer we we are using MVA ratings
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what is the interrelation between voltage current torgue speed and magnetic flux in case of different types of electric motors
The windings of a transformer are divided into several coils, because?
how to estimate wiring ins roughing ins. and boxes
The power supplied to a 33microF capacitor from a 120V, 60Hz source will be
what happen if field of dc shunt motor opens? what is function of putting res. in parallel to one phase of 3 phase IM? the power supplied by 5A source in circuit is given by------Watt.
I have 2 KW electric water heater.I am gonna use it in controlling water temp.so I needed to increase or decrease the heating capacity.is there any electrical-electronic circuit for varying the resistance & so current?
How to do stting of vl250 siemens MCCB
relation between power station capacity and voltage level?
What is the most accurate way of testing ELCB?ELCB is better than RCD?
What is given by the definition in BIL IMP/PF = 950/395 kV. This was found in a name plate of a power transformer.
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
How to use earthing on shipments.
in ring main system we use the isolater b/w transfer bus and main bus if we r not use isolatar than wat will be the effect in our sys.
What is the minimum IR value of HT/ LT cable? Pls post separetely!!!!!
Leakage current,un balance current which relay using for high voltage transmission?
