Answer Posted / nazir
Ring Main Unit is a switch gear, basically it is used for secondary distribution. Main advantages:
RMU is maintenance free and very compact in size.
Govt. Launch APDRP Scheme for State Utilities
to modifying their Distribution network by RMU.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is power factor why we should maintain the power factor unless what will happen
Can we use both Electrical & mechanical interlock between tow breakers? if yes how, please explain
can any one know is sbi interview based on merit or based on roll number
wheather the size of windings in motor and generator are the same
Please give me a erda placement paper
How much should be the load percentage for 15kva Inverter and Iinut & I output load with Calculations
what is the soft starter principle? how is connection diagram? what is the procedure for checking the connection?
Pls tell me whether we can use EN3A material for shafts of Permanent magnet alternator.What will be the effect of magnetic and nonmagnetic material for shafts on magnetic properties of PM rotor .
What do you mean by dependent and independent voltage sources?
in single phase converter, the no.of scr's conducting during overlap a)1 b)2 c)3 d)4
WHY THREE PHESE SYSTEM VOLTAGE APPLIED IN 440 VOLT
my UPS suddenly goes off and all panel light also blow off.This happens even main electric supply is not interrupted.After some time it automatically starts functioning normally.Batteries are new.
List of equipments required foe industrial repair lab.
what is the minimum (Common factor) insulatin resistance of the following a, 4mm sq wire b, cable from 50 mm sq to 800mm sq
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?