Interested to Buy Any Domain ? << Click Here >> for more details...
what is cogging and crawling
- 20 Answers
- 86466 Views
- ABB, Ashok Leyland, Bharat Bijlee, BMRCL, MN Dastur, Siemens, I also Faced
- E-Mail Answers
Answer Posted / soughata kanu electrical engin
Cogging means when the stator teeth s1 and the rotor teeth s2 faces each other respectively on the sam time.And due to this is called magnetic locking or cogging. It is found that the reluctance path is minimum when the stator and rotor teeth face one opposite to each other...
On the other side crawling of an induction motor is not but when the squirrel cage rotor exhibits to run very slow speed as low as 1/7 of their synchronous speed. This phenomena is known as crawling of an induction motor..
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
At what speed 1 HP motor can run an electric car of weighing 400 kg?
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
what is the max. acceptable leakage current in 33kv bus bar
Can i use the B-curve MCB instead of C-curve MCB
What are the basic component of a cro?
how oltc works in rectiformers of higher rating (27 mva,200v dc,120kamps) please provide me full information with diaggram.
I had applied for JE in PSEB, Can you pls send me the Question bank for related to my field
How do you determine the size of transformer radiators in a transformer?
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
What is the maximum No. of out going mccbs permitted from an LV distribution paqnel? What is the ampere relation between incomer and out going switch gears/mccbs?
On Which Pressure PRV is operated.
how can calculate resistance box for 15 kw, 6 pole, RV-230, RA-42 motor
Why to keep capacitor bank off while generator running.
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
