What may be happen if neutral and earth is shorted in a
substation
- 3 Answers
- 5278 Views
- Bureau Veritas, I also Faced
- E-Mail Answers
Answer Posted / kuruva eresha
Thier is no change in power system
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Saving in copper achieved by converting a 2 winding transformer in to an auto transformer is determined by A voltage transformation ratio B load on secondary C quality of core material D size of transformer core
Why do we use center tap transformer that used with portable tools
Advantages of using generator circuit breaker (GCB) scheme in a power station ?
whats the application of voltage regulation? and whats the voltage regulation's device?
Please brief working principle & construction of permanent magnet AC Servo motor
kindly send me 11KV MV motor differential protection procedure by primary injection method.
What is icu and ics in Acb and how many time icu or ics passes from breaker?
What is formula calculation size cable wire ?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
Is there a standard depth of gravel fill in Substation Switchyard? Please give a design/drawing. Thank you.
What is the working principle of CFL & T5 tube light & 40W tube light with electronic ballast?
when qty of cable being purchased is not sufficient according to the standard,what should the inspector do to ensure its quality according to the standard?
How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.
How can we checked Killo Watts of Motor & Alternator?
What are the commonly used schemes for the bus zone protection?
