Answer Posted / aamir
1-one reason of using MOV instead of control valve is that "MOv has low pressure drop then control valve"
2-Mov are useing electrical power supply. so no need or pneumatic or extra supply.at some places we can not provide pneumatic supply to control due to long distance,so we use MOV.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
why is not useing in boiler skin thermocople
What is instrumentation measurement?
how can we tune a PID. If it is by zeiger nichols method..please explain briefly with help of an example.
i am preparing for BARC ,so plz mail me how to prepare for BARC. ALSO IF POSIBLE SOME RELATED QUESTIONS. MY MAIL ID IS khushi_4uall2003@yahoo.co.in
A flange is used for instrument connection for a system with a design temperature of 316C (600F) and a design pressure of 1000 kPa (145 psi). What is the class rating of the flange to be used for this application? Explain your answer
I have energy meter for educational project having 0.5s class but my friend need 0.2s class meter , which one is good for that purpose and what is the actual difference of that two classes , need very easy example also.??
why we use 3 wire rtd direct wiring for temperature measurement instead of temperature transmitter like bearing temperature
Why is the orifice tab provided?
Explain signal isolator
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
what is the field bus calble ? what are diffrences in orang colur cable and black coular calble ?
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
Draw a great bridge circuit.
the 3 most common transmitter protocol being in refinery or qatar gas and aramco.
