Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / abu maryam
cavitation occur when any pressure drop happen and this pressure become lower than vapour pressure and it make notch in pipes or valves.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how many maximum enter 2mm Dia solid cylindrical pipe into 8mm Dia hollow cylindrical pipe. give answer with calculation.
How to convert Differential pressure to flow in TPH
What is three element in drum level?
Give 2 application of quartz crystal used for process parameter measurement.
State bernoulli’s application.
What are the different types of thermistors used in industries? How to the operation of typical thermistor?
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
how to control pid
How the warning lamp of a charging-system is activated ?
why we take %i0.0 as input for twido plc
what is diffrance between FF & SMART, explain with difination
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
hi! i want to know about mpse exam.
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
What is PDS and PDMS ?
