Interested to Buy Any Domain ? << Click Here >> for more details...
what is the role of MPU in DG set
- 1 Answers
- 10512 Views
- Weltech Engineering, I also Faced
- E-Mail Answers
Answer Posted / sheikh
MPU means is magnetic pickup unit , MPU is a spreed sensor which shows
Speed along with a techo meter. and somewhere transmit the signal for load
sharing device in a gen-set controlling
| Is This Answer Correct ? | 11 Yes | 2 No |
Post New Answer View All Answers
What will be advantage if we put some load in neutral of grounded star transformer & loadshortcircuit current,rated current of cable & MCB with example?
how to apply b license to c license in tneb
Why should we hire you over the others waiting to be interview?
What is 100% protection of generator? Why 100% is not used but 95% is generally used?
Is it posible to instal one more SMDB from the existing SMDB and is it practical.
Percentage losses in power generation?
How may I enrol or get admission to your program?
why current flow to the opposite direction of flow of electrons???????????
at what rate the micro controller increment its timer....is it 1micro seconds or 1/(12*10^6) seconds
how to select proper cable for ct wiring so that drop within the limit.
What is the rating of circuit breaker needed for 300 KVA load in 33 KV supply line in a transformer of 33 KV / 415 Volt ?
What are the parameters of water ( Water quality )to be monitored in Centralised HVAC ( water cooler chillers )
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
what is the chemical name and formula of refrigarent R-134a.
