Interested to Buy Any Domain ? << Click Here >> for more details...
What is the function of positioner in control valves? does the control valve operate without positioner?
- 3 Answers
- 5326 Views
- Hofincons, I also Faced
- E-Mail Answers
Answer Posted / jagan kumar
Positioner in control value is used to provide feedback about the position of the value. ie: How much value is opened eg: 74%. control value can be operated without the positioner.
| Is This Answer Correct ? | 0 Yes | 6 No |
Post New Answer View All Answers
Can any body help to get Rsemulator 5000 free from internet if possible then give me any link or any help .
Why do you want to work here
Tell me the field calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter.
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
use of split range ? where it is used ? in which control loop it is used ?
Why do we floating DC in DC system.
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
which type of filter gives the constant phase characteristics?
Draw symbols of the following :
what is the advantage of submersible level transmitter compare to ultrasonic level transmitter?
What is first echo & echo window in radar type level transmitter?
Can Any body tell me how to check Modbus Settings in ER300N L&T trivector meter?
What is frequency factor in massflow meter? When using frequency output?
we have level transmitter for h2s04 storage tank capacity 10k ,always there are failure of transmitter due to failure of magnetic floats ,please come up with solutions at the earliest.
why any measurement made interms of pressure is more accurate ? to be more precise most of the flow velocity is made interms of pressure and it is accurate. what is the reason behind pressure measurement being accurate ?
