Question 56 - The kinetic behavior of an enzyme could be described using Michalis - Menten equation : Vo = Vmax [S] / (Km + [S]). Derive this equation from [ES] = [E]total [S] / (Km + [S]), Vmax = Kcat [E]total, Vo = Kcat [ES].
- 1 Answers
- 1999 Views
- I also Faced
- E-Mail Answers
Answer Posted / kang chuen tat (malaysia - pen
Answer 56 - Vo = Kcat [ES] = Kcat [E]total [S] / (Km + [S]) where [ES] = [E]total [S] / (Km + [S]). When Vmax = Kcat [E]total, Vo = Kcat [E]total [S] / (Km + [S]) = Vmax [S] /(Km + [S]) (Derived). The answer is given by Kang Chuen Tat; PO Box 6263, Dandenong, Victoria VIC 3175, Australia; SMS +61405421706; chuentat@hotmail.com; http://kangchuentat.wordpress.com.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are the uses of quicklime?
If sum one has HAL placement paper plz mail me ,I m Chemical Engg.my id is er.kotnala@gmail.com
any meter avilable for measureing the Transformer Losses. ( like Voltmeter for voltage & ammiter for currenr )if yes plz give the make & supplier address, Email, Phone number.
Is four stage graphite steam jet ejector is possible. Any body can provide its design
What is the order of a chemical reaction, , if the rate of formation of 'C', increases by a factor of 2.82 on doubling the concentration of 'A' and increases by a factor of 9 on trebling the concentration of 'B'?
How can one estimate how the friction factor changes in heat exchanger tubes with a change in temperature?
what is isochronus and droop speed?
Why is post-weld heat treatment sometimes necessary for welded vessels?
What is quicklime and what are the uses?
What compounds are responsible for the odors that come from wastewater treatment plants?
Do you have recombinant protein expression experience? Explain?
Name some common causes of control valve noise?
Explain the some guidelines for sizing a psv for a fire scenario on a vessel in a refinery service?
What are the frequently asked technical questions in chemical engineering during PI?
What is the method adopted to minimize shell side pressure drop in a shell?
