Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mano
the induced EMF when the field current is zero is known as residual voltage
| Is This Answer Correct ? | 15 Yes | 1 No |
Post New Answer View All Answers
What is time response of the control system?
Draw the equivalent circuit of crystal oscillator?
what is the transmission loss for electrical supply? specifically a large shopping complex where the grid is half KM away, what will the % of transmission loss? is there any transmission loss for captive unit generation for above set? thanks
Classify milling machines.
What willbe change in programming when we use 5/3 solenoid inplace of 5/2 in operating of a cylinder?
1 hp is equal to how much watt?
what is KA rating and how can we choose switchgears on applications
how much maximum load a 2 core (Single phase) 16mm aluminium wire can take ?
Is Transol transformer oil comparable to nynas nytro libra?
What is the settings of distance protection relay in 400 kv line
why the difference arise between HT reading & LT reading (submeters fixed in complexes, apartments etc)if the power factos exceed from 0.9 to 1 can the ht meter reads fast?
what is meant by impulse voltage?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
why servomotor motor? where i apply for best output?
WHAT IS THE TECHNICAL SPECIFICATION OF C CURVE & D CURVE LEGRAND MAKE MCB
