1 tr is equal to how many Kw .is there any specific formula
for this to get the result .
- 13 Answers
- 122053 Views
- Cipla, LG, NSN, I also Faced
- E-Mail Answers
Answer Posted / david joson
The TR for the ACCU is determined by its efficicient Coefficient of regrigeration or the (COP) Coefficient of Performance. It ranges from 1.5 to 2 max value depending on its voltages. Thus 1TR=1x1.5x746=1119 watts or 1.5 hp
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
After doubling voltage from solar cells & use step down voltage transformer can we get high current output with low voltage.
BRIEFLY EXPLAIN THE STORAGE CLASSES AND THEIR TYPES IN C
What is meant by derating factor?
how to calculate sizing of NGTR (Transformer rating,Loading resistor value and Current rating of resistor) and what is the X/R ratio. Details : 11kV,Capacitance 1.73532 micro farads,40kA for 1sec.
I WANT YHE TECHNICAL AND ELECTRICAL SPECIFICATIONS OF 2x4MW 11KV 2x10MW 11KV 2x25MW 11KV 2x100MW 11KV HYDEL POWER PLANT i.e PROTECTION SYSTEM,MONITORING,CONTROL SYSTEM,GENERATION,SYNCHRONISATION,METERING PLEASE SEND THE DETAILS TO MY MAIL ID SPRAVEEN_222@YAHOO.CO.IN
what is the effect of change in supply frequency on load angle of synchronous motor,all other parameters remaining same?
I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.
How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?
how to ctrl motor by use of ac or dc drive.plz explain evdintly
What happens when two positively charged material is placed together?
Graphs of measuring power and speed on dc motor
we can run 2phase as 3phase .what will be the differnce with respect to phase angle, power, current between the two modes
What is PEC??Applications........
Why PS class CT is always preferred for Differential protection?
'documenˁ
