Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / vinodbagre
Considering 3-phase power, In Balanced loads the load at each Phase are equally distributed & In Unbalanced load the load at each phase is not unequally distributed.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
transformer phasor diagram under load explain it?
what is Different between Bilinear and Unilenier?
Sir,In our company there are 3 caterpillar make(capacity:(1) 3.3KV,2.5MW(2)3.3KV,2.5MW & (3)3.3KV,1.9MW) & 1 deutz make (capacity:11KV,3.8MW)gas engines utilised,all are running in paralell. There are three transformer utilised,(1) 6.25MVA,3.3KV/22KV,Impedence voltage:6.7% used for two generator,both are 2.5MW(2)5.5MVA,3.3KV/22KV,Impedence voltage:7.2% used for one generator of 2.5MW & (3) 5.5MVA,11KV/22KV,Impedence voltage:7.8% used for one generator of 2.5MW.all generator breakers capacity of 1250Amps. Sir,I want the details of fault level calculation of generator,transformer individually & for whole system. If you require any information from me.feel free for contact me sir.pl.send the answer of my question as the earliest as possible.
What is the efficiency during maximum power transfer?
What are reasond for high wattage in single phase induction motors
block diagram of 2 ups system connected in parallel mode?
What is meant by coupling capacitor?
What are gain margin and phase margin?
WHAT IS VCB SAFETY
With a phasor diagram show the effect of increasing the field current of a generator supplying a constant real power and connected to a grid system.
to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????
What is ST and specify its range of voltage.
what are the different methods for the starting of a synchronous motor.
How can I calculate per unit (KWH) fuel (Gas/ Diesel both) consumption 1MW unit?
UG cable sizes were specified in sqmm. But practically its not coming to mesure. What's the reason for that? And how they specify the size of the cable?
