Interested to Buy Any Domain ? << Click Here >> for more details...
3.7 kw motor ,how much sq mm cabel want to bare this motor load
- 1 Answers
- 2886 Views
- I also Faced
- E-Mail Answers
Answer Posted / gopal
In case of copper cable 2.5 sqmm is enough. For aluminum 4sqmm is better. Since full load current of 3.7kw motor is 6.4A.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
What is PQA???Applications........
how to calculate the battery AH
Why MCCB is Getting tripped sometimes when there is no load in the Midnight ?
IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?
After synchronization with grid what is the demand value QKVAR and how we will maintain that?
why can the rotor of 3 phase slip ring induction motor not be a 2 phase rotor?
sir i have a car stereo system and there is jack on him so can u tell me a way to find out their power terminals on the jack or on the circuit board"
the typical output of a solar cell is........
what is strip power factor?
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
how to modify DOL control panel into Delta Y connection?
What is kirchoff ’s current law (kcl)?
Explain the difference between verilog task and verilog function?
HOW TO CALCULATE EARTHING SIZING?
all the technical question with answers pleas send your email id ramar_eee@yahoo.com
