in 8051 micro-controller
is it must necessary using external oscillator ?
shall we continue without oscillator for simple logic purpose?
- 1 Answers
- 2026 Views
- I also Faced
- E-Mail Answers
Answer Posted / mahendra chakole
No, because it first pulse signal generate to operate without oscillator not used.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
what is inductive couplers
What is meant by input power factor in controlled rectifier?
when do we use capacitor and inductor as strong device
Explain the importance of if in radio receiver?
What are different categories of antenna and give an example of each?
I am studing Diploma Electronics from International Council for Management Studies-CHENNAI. Is it useful for getting engineering job within india or international ?
How the current is reduced to zero in a photodiode?
send me few previous years section engineer question papers?..
i having one cisco 2950 switch,but i having no rights of ythis switch,now i want to know switch macc addrerss of particular network ip,how can i resolved?
How can we remove unwanted sideband from ssb modulation?
WHAT IS THE DIFFERENCE BETWEEN BIIS-B AND BISS-C INTERFACE
Explain the differences between voltage and current controlled devices?
What is an asic?
The positive clipper can be easily converted into negative clipper by A Reversing diode and changing the polarity of reference voltage B Reversing diode only C Changing the polarity D None of these
draw the interface diagram of 8085 microprocessor having input ports at 23H, 2FH, EFH, and output ports at 44H, 2FH, EFH, and FFH using NAND gates only.
