what is necessity of using isolation transformer?
Answer Posted / balmukul sharma
Basically it established the isolation b/w high power circuit and low power circuit. Like in Electronics they dealing with low powers.
If not, then the secondary circuit load may get damage from high power.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
hello! sir i did three year of diploma in electrical (2007- 2010) and now i m a student of electrical engineering. sir can i apply for germany visa for study and part tome work over there?
What is Icu and Ics and what is difference b/w them. please tell me how to calculate a size of a copper bar for a system or a breaker... reply on... king.arish@gmail.com would be waiting for a logical answer.
How do you determine the size of transformer radiators in a transformer?
what is the reason for indication of light in the earth lamps of main switchboard.if there is an earth why does one lamp get dim and the other two bright.
how does WTI work ?
What is the difference between PS & metering CT (5p20,0.5 etc.)? Why in PS class CT only Vk is given ? Is PS class CT is more accurate than metering CT?
What can you contribute to the progress of our Company as an employee if you are selected?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
1hp= how much rpm
Please define ohm’s law for a.c (alternating current)?
Why you are switching off arc protection mcb when you are taking shutdown for lv board.
In what cases (circumstances)we should apply P controller, PD controller, PI controller & PID controller ?
sir my exam is on 19/6/2013 under electrical branch pls send me sample aptitude questions as well as sample technical questions for jindal steel and power company
what are the basic insulation levels & what its Unit
what will happen if frequency is below 50 hz?