Yokogawa dcs normally where will change 4-20 MA to DC voltage( node or I/o cards?)
Answer Posted / gautam
I/o card
Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
Meaning of the following a. IOP- Manimum; b. IOP- Maximu,;
Displace type LT to be calibrated in workshop, wt. 40, dia- 60 mm, density- 0.8kg/cm3.
How to erection of DCS Panel at site step by step
Sir, I want junior executive, Instrumentation question papaer for IOCL, Plz send to arabinda.ghosh83@gmail.com
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
defination of radial vibration?
How it the difference between force balance system and dispalacement balance system?
Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?
Give an example where you had aproblem on the job, and tell me how you solved the problem. and the finalvoutcome.
how to calibrate steam control valve in steam turbine
hello can yoy pls send me previous papers of jindalpower and steel ltd.....'m from instrumentation..... mani1048@gmail.com
In turbine what does term CDP, NH, HSSOC means.
Which type of pressure can be measured by primary elements?
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
Whether the DI, DOs shields can be connected with Analog Input Shield Earthpit?