Interested to Buy Any Domain ? << Click Here >> for more details...
difference between a four point starter and three point
starter
- 9 Answers
- 79013 Views
- I also Faced
- E-Mail Answers
Answer Posted / anil kumar behera
In 4point starter a brass arc is present which is not present In 3point starter. A protective resistance is present In 4point starter which is not In 3point starter.
| Is This Answer Correct ? | 8 Yes | 8 No |
Post New Answer View All Answers
what is the use of power transformer in GSS.
pre arcing time of ehv breaker
Explain the advantages and disadvantages of hydropower plant?
how to calculate the breaking capacity of different breakers.
if i am in front of transmission line how to know that current direction without any equipment
Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices
Define demand factor?
What is resistance reading of earth copper rod with grid and without grid?
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
Difference between RCCB, RCBO and ELMCB.
What tests should i carry over on a newly rewinded DC Generator with voltage rating of 38 volts and current rating of 350 amps, to certify that the machine is OK?
what are factors to be consider to design a HT & LT motor?
which pump used in STP
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
If the line voltage is reduced to 75% of its rated value then by what percentage current will reduce ?? 75% 25% 50% no change and why ?
