What is working principle of ACB and VCB?
- 9 Answers
- 68229 Views
- Greenko, HCC, I also Faced
- E-Mail Answers
Answer Posted / gomez jerald
An ACB Is constructed for a particular contact rating at medium voltage .Technical explanation the contacts energize and d energize the arcing air medium during the process is quenched in an open chamber.
VCB is constructed especially for higher rating voltage and the technical term .the arcing during energizing and d energizing is quenched in closed chamber at very low pressure.
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
What are two contours of nichols chart?
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
how the phase convertor changes the no. of phases
What is the difference between voltages or potential difference? And what are they?
defination of transistor controlled series capacitor
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
how could we know the size of cable by physical view?
PLEASE INFORM ABOUT THE IDEAL TEST RESULTS OF MAGNETIC BALANCE TEST OF TRANSFORMER 33/11 kv DELTA-STAR T/F
sometime battery charged and then automatically charged when rectifier ON conition, is there any chances please clarify the same.
comparision between ACB and VCB
can someone explain that how the speed of the protection system affects the fault level calculation?
can we conduct the swineburne's test on a dc series motor? why?
Define active and passive network?
As we use capacitior bank in 3ph ckt for improvement of PF, why not we use capacitor in single phase domestric use, at our house their are many inductive equipments,like fan,mixer,tube choke,air conditioner they also draw PF... by using capacitor can they improve PF. if yes--what are advantage and how to connect a capactor in single ph,and which type of capacitor if no- what are disadvantages.
what is the purpose of silicon dropper used in battery charger?
