Interested to Buy Any Domain ? << Click Here >> for more details...
What is the purpose of starter and choke in tube light?
- 9 Answers
- 113312 Views
- Chimay Brewery, TATA, TSPL, I also Faced
- E-Mail Answers
Answer Posted / waqas khawaja
aslam o alicum dears
choke is work as a blast(give initial force) by increasing voltage which is require to excite electrons(light up) of floroscent gas in tube and after this it provide possible current needed by floroscent-gas.
while starter is used to have high current as to excite the gas...
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
when the Transmission and Distribution network where is the "feeder" lines are located? and why should be used in T&D network.....
How does an induction motor start?
What is difference between unity power factor wattmeter and upper power factor wattmeter? In short circuit test of transformer the wattmeter used is unity power factor type or upper power factor type wattmeter?
What is lc oscillator?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
What is frantic effect?
what happens when series resonance occurs?
During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?
we have 3.5MVA-11/6KV transformer. how can we calculate earth fault current and NGR calculation?
what kvrah y we need to take the readind of that
what happens when dc generator coupled with cycle shaft.also explain what happens when its loaded
What consists of 2 or more thermocouples to be connented series?
can you send me the placement papers of electrical engg. from companis like NTPC,DRDO,IOCL,HPCL,BPCL etc.?If,plz send as soon as possible.Thanks.
how r charge carriers produced
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
