please help me to find a mix design ratio for M40....
- 2 Answers
- 2842 Views
- I also Faced
- E-Mail Answers
Answer Posted / gowtham raj
The answer is 1:1.42:2.86 is correct
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How to calculate the force on a column of three story building. What should be the base concrete height?.
What is the difference between Fe 500, Fe 500 D and Fe 515.
Please design 12.5m long dubbly beam
In foundation design, while we do the base pressure check, we normally check if the attained pressure value is less than the GROSS BEARING CAPACITY of the soil which is the sum of net bearing capacity of soil and the overburden pressure. Actually, the overburden pressure acts against the net bearing capacity of the soil and I feel that we are actually increasing the bearing capacity value and doing the check. I feel that this is NOT right. Please clarify on this.
When column of building is abutting the boundary line,then suitable footing advised is
can i make bricks using M10 grade concrete ? and what would be the cost of a brick if we use m10 grade concrete sand and aggregates ??
What is the ratio of grades m5, m7.5, m10, m15, m20, m25, m30, m35, m40?
How to calculate cement, water, fly ash amount for 1 cum if the w/c ratio is 0.4 and fly ash to cement ratio is 1:9
How to avoid fly ash seed ball formations in the concrete mixer while mixing of raw materials for fly ash block manufacturing?
Why M15 is replaced by M20 when ammendment are made in IS456 in 2000?
how to calculate freeboard in under ground water tank and technical details
sir please send me campus placement questions in civil engineering
how to calculate the crushing strength of cement concrete paver blocks 100x100x60 mm thich.
How to fix toll charge for a particular vehicle at toll booths in a highway?
How to compute minimum number of columns required for a site from area of site?
