Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / vaseemzehak
Cement is a binding material which made by argilaceous and calcareous material.There are two process of cement making:
1-wet process
2-dry process
Most popular to make cement is dry process.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is boucholz relay and the significance of it in to the trformer?
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
What is the de rating factor of cable? What is the importance of the de rating factor in cable selection?
why -48 volts dc used in telecommucation
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
In PFI plant one stage capacitor connection is directly connected(with out megnetic contact controll). but why?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
How to calculate approximate load loss of a distribution transformer by knowing %ge imp of transformer?
Mention the methods for starting an induction motor?
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
What is the drawback of static coefficients?
why ct ,cvt should be stored in a vertical position?
r we are using in gas turbine mark (5) frame (6) (made in india Bhel 1997) Ā
What is the method for testing the differential protection stabilty in generator? When the time of starting What will happen if differentail protection connection wrong means?
Why the standard of ambient teperature mentioned as 40 degree celcius in machines.
