what is humming noise and wha is the reason to develop
humming noise in a mv pannel ?
- 2 Answers
- 4587 Views
- HPL, I also Faced
- E-Mail Answers
Answer Posted / amit
humming noise is a sound produced in power transmission line during the transmission of power.it is produced due to corona effect.it can be supresed by using stranded wires..
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
WHAT DO YOU MEAN THE DIFFERENT TYPE OF CURVES OF RELAY LIKE STANDARD INVERSE, VARY INVERSE, NORMAL INVERSE, LONG INVERSE ETC....
i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.
What effect does a very low impedance have on the Voltage regulation? On the short-circuit current?
We have 110Vac ,10A ac supply which is converted into 110VDC & How much DC current? which factor is reqired for dc current calulation?
How to Calculate The Neutral Earth flat design calculation for the Synchronised generator (Gen 1-650Kva, Gen 2-725Kva
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
What is the capacity of the Fastners 12mm?
explain the types of drives
why magnetising curve not start with zero voltage?
internally connection of photvoltic module
What is transister define the transister ammiter ,base, colector.
Why do we apply both Differential and REF (HV and LV) protection schemes on YNyn configuration of a transformer?
how many single tension hardware are required on a double circuit transmission tower?
Working of microwave oven?
