Interested to Buy Any Domain ? << Click Here >> for more details...
what is the pressure in the tank when its level of liquid is 1.5 meters when its total capacity is 2 meters
- 2 Answers
- 3659 Views
- Engro, I also Faced
- E-Mail Answers
Answer Posted / ahmed
the level will be .15 bar in based on the liquid in the tank is water and the pressure is absolute pressure
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
In Safe Guarding test what means by "Failed to Danger" ?
Sir, I want junior executive, Instrumentation question papaer for IOCL, Plz send to arabinda.ghosh83@gmail.com
Give Detail information about plc,dcs,and scada system?
What are the types of control valves available
sir, i preparing hpcl,ongc,barc,hal exams(instrumentation engg)pls send a placement papers
How vortex sensor used for steam flow measurment can be checked on line i.e without taking out from process line.
this site is owned by an nonsense
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
What is force balance principle?
how can i calibrate the temperatuture gauge used by temperature bath(dry block) i mean step by step procedure?
What is zone,loop/fire alarm system?
hi friends,im an instrumentation and contol engg student,can u hlp me of suggsting barc written question paper,my id is roysuvaranjan@gmail.com, cel no.9563591747
a flow transmitter [range-0-400mbar] connected in process line. please explain me how to calibrate the flow transmitter , & how to do static error
