Interested to Buy Any Domain ? << Click Here >> for more details...
what is the working principle of dis-placer type level transmitter
- 1 Answers
- 2993 Views
- Sendan, I also Faced
- E-Mail Answers
Answer Posted / vivekg17s
This displacer LT work onArchimedes' principle that indicates that the upward buoyant force that is exerted on a body immersed in a fluid, whether fully or partially submerged, is equal to the weight of the fluid that the body displaces. Archimedes' principle is a law of physics fundamental to fluid mechanics.
So change in weight of displacer will be directly proportional to level of lequid and that signal will be sent to LVDT which will be converted to 4 to 20 ma
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
Why grounding is necessary? Give example with diagram.
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
how to convert cubic metre per hour to newton cubic metre per hour
pls provide me syllabus and old question paper of instrumentation engineering for GET(JSPL)
can you send remote seal interface level transmitter calculation steps for oil water saperator.
how do calibrate the valves.. with clear manual
How can i copy program (parameter) from mm440 (V.F.D.) by using BOP?
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
line up procedure for dp type flow transmitter?
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
Why we are using DPT(Differential Pressure Transmitter) in separator instead of level trasmitter?
How to Calibrate Ultrasonic flow Transmitter in Field
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
what is different between 2,3&4 wire rtd and how much maximum distance using plc to field.
what is the difference between profibus and controlnet networking.
