Why resistance is not measure in running conditions of motor
- 1 Answers
- 2365 Views
- Falcon, I also Faced
- E-Mail Answers
Answer Posted / henil patel
During the measurement and immediately afterwards, some of the terminals carry dangerous voltages and MUST NOT BE TOUCHED.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
for 750 kw LT load what will be the ht kva
what happens to the supply voltage if there is any change in frequency?
on a three-winding transformer relationship delta-delta-star, on third winding why the relationship is a star? what are the advantages and disadvantages? Thank you and please help
Why is voltage is required to be within permissible range for an electrical equipment?
How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?
why Induction Generators are not "Black start" ? and apart from WTGs where this types of generator are generally used?
how calculate gd2 of ht motors
Can Anyone suggest the Standards (IEC or IS) for selecting copper current density?
what is the difference between active power and reactive power and apparant power in practical as well as theoritical
How to do bus bar short circuit calculation for 230KV/11kv, 60 MVA Substation?
how to calculate sizing of NGTR (Transformer rating,Loading resistor value and Current rating of resistor) and what is the X/R ratio. Details : 11kV,Capacitance 1.73532 micro farads,40kA for 1sec.
HOW TO CALCULATE THE VT SIZING?
what will happen reduce the transformer voltage from 415v to 406v, is it save the energy,? are this methodis good to reduce the energy.?
Explain what is clipper and clamper circuits?
What is the minimum value of hfe for the oscillations in transistorized rc phase shift oscillator?
