Interested to Buy Any Domain ? << Click Here >> for more details...
1.why can't we used sea sand in construction?
2.can we change sea sand into normal sand? if yes how?
- 2 Answers
- 8510 Views
- I also Faced
- E-Mail Answers
Answer Posted / balu reddy
because sea sand contains large amount of salt particles and also dirt particles like macro microscopic.it is very expensive to remove them, but in some countries like Sri Lanka and ningbo are using sea sand for construction
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Advantage of Aluminum form work in terms of activities can be skip and cost too
what is Short bored pile foundation.
how to calculate the density for high density concrete ? or is it same as the density of RC?
What is the difference between undo & redo?
If we are providing concrete joint in every 10m with water stopper in water tank wall then is it necessary to cut the steel at joint section?
Design a cantilever type retaining wall to retain sand for 4m above the ground. The sand fall slopes at the rate of 1 vertical to 2 horizontal. The weight of sand is 18000 N/m3, the angle of repose being 30. The safe bearing capacity of the soil is 200 kn/m2 at 1/25m below the ground level. Use m 15 concrete mix.
What is the diff b/w ROAD TUNNEL & RAILWAY TUNNEL ??
what is Quantity of stone and sand required for one cubic meter of stone work (UCR)
What is the difference between absorption & adsorption and sorption?
how to determine the correctness of proportion used in cement mortor and various IS codes to determine the same?
i have to give lap joint fo 1Mtr steel of dia12mm,whenever i did mistake i cut less 5cm plz tell me how much i will give lap joint so that length comes 1Mtr
What is the procedure and technnology behind jointing of prestessed block in Delhi metro rail project.
Different sizes of Hollow blocks and its weight. Thanks.
how we can find sieve #4 is 4.75mm?
The concrete slump recommended for beams and slabs; is?
