Interested to Buy Any Domain ? << Click Here >> for more details...
what are the types of starter ?
- 25 Answers
- 192915 Views
- Andhra Sugars, Bhel, Eveready, HyFun Foods, Jindal, ME, Valeo Lighting Systems India Private Limited, I also Faced
- E-Mail Answers
Answer Posted / prabhat chauhan
1- star delta starter
2- direct on line starter
3- auto transformer starter
4- soft starter
5- variable frequency drive
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
what is vtg limit of earth and neutral at transformer side?
Define active and passive network?
How to calculate pitch, gauge of winding wire, and No. of turns for 30HP, 3 phase, 4 poles 50Hz, 380V induction motors
How we can calculate the consumption in kwh of motor on basis of kw @100% load, @50% load & @ no load.
I HAVE A INCOMING 100A MCCB TPN 25KA, CABLE LENGHT OF 80M 70MM CABLE SIZE FROM MAIN SUBBOARD TO NEW DB.BASE ON THE FAULT LEVEL SETTING OF 45KA.I WOULD LIKE TO FIND OUT 25KA ENOUGH KA. APPRECIATE IF SOMEBODY CAN ASSIST ME WITH FORMULA FOR THIS. FRM: JEFF
This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.
Advantage of LT panel vs HT panel
in Telecom DC system-why positive +ve is made earthed.and - ve is fed to load.
l&t switch FN 63 handle position can we change
what is 30-phase of transformer
What is difference between start imitation and start interlock for 3 phase motor protection ?
what is the meaning of neutral displacement ???
What is the basis for framing the rules of block diagram reduction technique?
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
How cmd is calculated in case of energy neters
