Interested to Buy Any Domain ? << Click Here >> for more details...
why we use mostly 3-phase but not 4-phase and 5-phase what
is the difference between them
- 1 Answers
- 3306 Views
- I also Faced
- E-Mail Answers
Answer Posted / skm
I had same doubt too. In indusrty sector three things are most important while choosing type of connection, i.e. 1. Quality, 2. Cost, 3. Reliability. Higher the phase higher the power delivery capacity and higher the efficiency. But as we use multi phase system the complexity of system grows higher with increasing number of phases. Also it is wise to use economical way to run the equipments. So as a standard three phase connections are preferred.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the size of cable for 15kw motor and 85 meter cable length using with vfd
3 phase induction motor connection star or delta while using ac drive motor is .75 to 5.5 kw
As i want some model question paper in basic computer science and history please send me immediately sir
Please give me a erda placement paper
Explain the method to keep noises low in a control system?
what is earth pit , how we can measured it, what earth rods reference
Draw a block diagramof Three UPS systems connected in Parallel mode?
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
what is the acceptable limit value for Desolve Gas Analysis/
Formulae for calculating the transmission line losses for different voltage levels
why u r living from presentaly working.
state the disadvantages of carbon filament???
A car's starter motor draws a current of 100 A at 12,0 V when starting the engine. The mechanical power required to turn the engine is 960 W. At what rate is energy from the battery converted to non-mechanical forms of energy?
What conditions are required for transformer to operate at low frequencies ?
How the frame size of a flange mounted AC induction motor is calculated?
