Interested to Buy Any Domain ? << Click Here >> for more details...
how to calculate the size of the cable for a particular rating 3phase induction motor?
- 1 Answers
- 3038 Views
- Godrej, Megatron Solutions, I also Faced
- E-Mail Answers
Answer Posted / swaminathan m
depending upon the starting PF and the starting current (A) (or) Full load current and PF
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how can check the resistance of battery contact?
What is Instantaneous Earth fault relay,how will work
i need some project topics along with circuit diagram in the electrical adnd electronics engg and also give ome website regarding projects.my mail id is thenmozhi2k7@gmail.com .please help me.
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
What is meant by reactance voltage?
what may the reason for vector shift in a generator?
During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?
What are the types of feedback oscillators?
what topics we have to concentrate for power grid et.written test.and tell what to read for english synonyms and antonyms.
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
how solar power plant energy meter multiplication factor
IN dc capacitive reactance is??
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
In a voltage-controlled current source A A current booster is never used B The load is always floated C A stiff current source drives the load D The load current equals Isc
How do we calculate over and under frequency tolerance from generator data?
