Answer Posted / raja2016
safety barriers simply neglecting the spike voltages from the field that affecting the electronic I/O cards in the PLC system by fuse blow down in it
.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
1.what is the power consumption of three element drum level control in sugar industries? 2.how to reduce that?
what is interface level measurement.who can calibrate interface level measurement transmitter online
Who to difference between analog in & analog out in dcs?
what is the vital subject for scoring bhel exam&what is the question pattern
In a gas over oil actuator, after the opening/closing of valve, how the gas is vented out? How does the hydraulic/gas circuit function?
steps for installing orifice plate?
What is megering????
Describe the functions of the Operator Interface including the considerations related to alarming and display layout/configuration/layers.
HOW TO SOLVE PROBLEM WITH ENRAF LEVEL TRANSMITTER 854 ATG THAT PASSWARD DO NOT Exist INTO TRANSMITTER TO ADJUST LEVEL WITH PORTABLE PET 847, WRITTEN WRONG PASSWORD , I AM SURE THAT DEFAULT PASSWARD (W2=ENRAF2) IS THIS TRANSMITTER NEED TO REPLACE SOFTWARE AND HOW?
what is performance test.need defination
what are the values of fuel flow rate in various places in boiler.
what are the use of belew gear in general ??
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
I m appointed as an automation trainee engineer in small firm in that I am only the one , my company give me a project on s7-200 as i m beginner I don't know how to program so please send me the helpful site so that I complete my project before deadline....please help me out in this critical situation.
