Interested to Buy Any Domain ? << Click Here >> for more details...
What is meant by Resonance what are the different types of
resonance and what are uses of them?
- 14 Answers
- 50164 Views
- Infosys, NTPC, I also Faced
- E-Mail Answers
Answer Posted / shane e.
The frequency at which Capacitive and Inductive reactance cancel each other out at a given or "resonant Frequency" Creating an ideal 0 impedence or essentially very low impedence pathway.
Applications are: Stripping carrier waves from a modulated waveform on the recieving end so inteligencesignal can be amplified. Filtering out unwanted Harmonic frequencies by shunting them to ground.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the one main difference between ups & inverter ? And electrical engineering & electronics engineering ?
why we change the direction of winding in rotor ?how we make the north and south pole?
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
Can we use a absolute encoder to show rpm of a motor ? what about the condition when power is off ? what is difference if a incremental one is used ?abanirout@gmail.com
why we permissive overreach in distance protection.where it is applicable to use in long r short lines
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
Haw to check conductivity of budbar
I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?
If we have to find the inductance of a dc shunt motor then by giving dc supply or ac supply and what is the reason for it. (this example is from "to determine the transfer function of a dc shunt motor ")
how was your last weekend.
Is any generator is developed which is operated with out diesal or other expensive source?
what is the diff. between x'mer , isolation x'mer & ultra-isolation x'mer ?????????????
What is the function of the circuit breaker failure relay?
what is level 2 automation?
