Interested to Buy Any Domain ? << Click Here >> for more details...
Does the ELCB or RCCB trip when it is connected to a primary
side of a welding transformer?
- 3 Answers
- 10144 Views
- Tata Motors, I also Faced
- E-Mail Answers
Answer Posted / raghav govind
Because rccb works under unbalance current flowing in the desired circuit...if a man stuck, were in electric shock...if its in single phase protection breaker....the circuit will allow even current... Not unbalance current flow...since the breaker will not trip in this situation...definitely...
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What will be the impact on motor performance if a LT motor is rewound with changed motor winding data as given below:- Original winding data: total 04 wires = 02 wires of 17 SWG + 02 wires of 16.5 SWG. Changed Winding data: total 03 wires of 15.5 SWG wire size Motor rating: 160KW, 740RPM, 415V, ID FAN application. Normal Running Current = 95% of FL Current.
is this the formula of building wiring to get the main breaker.Watts/volts*.8%+higher motor*(25%)=ampere. yes or no or send the correct formula for building wiring.
What do you mean by transformation ratio of instrument transformer?
In which working principal temperature transmitter work.explain in detailed.
give single line diagram of D.G distribution form alternator to main L.T panel?
how we explain parallel paths armature winding?
why US countries maintains 110v and 60HZ
what is the minimum requirement gigaohms for the insulation test using 5kv in 300mm xlpe cable
A system absorbs 100 k J of heat and the increase in its internal energy is 100 kJ; the work done is
What is the loss of power of transformer 220kv/33kv,63/80mva of % imp12.05 at 80%load
how can we calculate the ampacity of the electrical wire/cable. and what are the factors must be considered. pls. elaborate.
How to calculate Air conditioning capacity for a telecom BTS shelter?
what is the mechanism of operation of brushless dc motor why is it more wexpensive then ordinary permanent magnet motors
Discuss about gear cutting machines.
can we use CBCT in neutral of solidly grounded transformer? in place of three phases we can pass only one phase which decreases the size of CBCT?
