Answer Posted / velmurugan
If Parallel operation with EB it should not satisfied the following conditions.
1. voltage
2. Frequency
3. Phase sequence
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is the formula for calculating no-load current?
What is the differentional relay...what is the work of this in power Tx. how it is works..
iam working in power plant. In hot places tube lights are glowing at the end portion only. what is the reason for that?
When a single pase capacitor run motor- run on 230vac and Case(1)run with 8 Mfd 250 vac.capacitor , Case( 2) run with 8 Mfd 400vac capacitor. What is difference between both case regarding power ,efficiency etc?
we have require a Motor (1500kW, 6.6kV, 50Hz) which shall operate at 1500rpm during 30min and after it shall run on 500rpm during 15min. The same cycle shall be repetitive during the whole working days. Which method is best and economic to achieve such type of task. VFD, VVFD, Pole changing motor etc.
what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:
What is tranformer differtial?
What is the basis for framing the rules of block diagram reduction technique?
wat is the first thing dat is needed, 2 lay a cable in some area??
why we can use 1 to 5V dc
howmany electrician should maintain for a 1000 kva used plant... in kerala..
In radial network the source is fed from 1 end both ends at central
what is the correct method for the outdoor termination of 19/33 KV HT cable step by step?
I WANT TO know WHICH WAY IS BETTER FOR CONNECTION BETWEEN POWER TRANSFORMER AND MAIN DISTRIBUTION PANEL. 1-IS BETTER WE USE CABLE? 2-IS BETTER WE USE BUS DUCT? my transformer rate power is 2500KVA
i want to learn control schedule for 11kv panel? can any one send the detailed control schedule?