Q2). When 3 dice are simultaneously thrown, which of the
following would be obtained?
(a) Result 1: “A 5, a 3 and a 6”
(b) Result 2:” A 5 three times”
(c) Result 3:”A 5 twice and a 3”
(d) All three results are equally likely.
(Musigma Question)
Answer Posted / shivani jain
(a)
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
explain the Trip supervision circuit
What is ST and specify its range of voltage.
How to calculate no of EARTH PIT? Describe the formula as per IS standard?
How many VSC based HVDC are there in India and the world
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
how the aircraft outer body and inner body is separated ?
defult setting in p220 micom motor proction relay for 11kv,640kw,f.l.a.-40a,1440rpm ht motor?
can we install HT panel & LT panel side by side or how much clearance is required ?
what is the differebt between ac and dc fuse?
WHAT IS ELECTRICAL MAINTAINTENCE ?
how to caculate cable size for diff types of loads? if anyone know the calculating procedure please tell me
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
When we use 3 terminal resistor?
in my industry we are using 3 step up transformers for induction heaters..i.e 415/580v and other are 11/440v.in power consumption does a step trnsformer makes any difference compared to step up?? plz explain
draw the full wave and half wave circuit of 3 phase system and inverter circuit used in ups