Interested to Buy Any Domain ? << Click Here >> for more details...
Single acting ON-OFF valve. it is air to open. when sov energized , valve will be open, so during that if air fail then what will be the condition of valve ( open or close ) ???
- 4 Answers
- 5966 Views
- I also Faced
- E-Mail Answers
Answer Posted / kausar
If it has airlock then it will be remain same because at the time of pneumatic failure it locks the air automatically.generally now with control valve airlock,booster ,sov and air filter regulator are arranged in order to make the line safe
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
What is modbus?
centrifugal compressor interlock? Tell me the parameter at which compressor will trip
Explain plc level and its type?
sir,would you please send me the Hindustan petroleum corporation limited papers(HPCL).my e-mail ID is ujjwal_sharma1983@yahoo.com
Q-Explain the different load conditions that will produced different offset which may or may not be acceptable to thhe control function
How does a single acting, spring return ball valve actually work? Does it require continuous air supply?
How servomotor controls throttle valve of TURBINE?
What are different types of orifice plates? State their uses.
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
hi friends,im an instrumentation and contol engg student,can u hlp me of suggsting barc written question paper,my id is roysuvaranjan@gmail.com, cel no.9563591747
What is super thermocoupal?
In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.
Draw a group of instruments interlocked to a Pump & Motor?
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
why Fahrenheit unit of moistur analyzer transmitter
