Interested to Buy Any Domain ? << Click Here >> for more details...
tell about various protocols used in different plcs
- 3 Answers
- 9127 Views
- Emerson, Samtel, I also Faced
- E-Mail Answers
Answer Posted / kmns
Master bus 300,field bus f8000, profibus, ethernet tcp/ip,
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
I have 0.75mm sq multicore cable (IS type) , can use instead of same type but 1.5 sq mm cable ? Note : The distance is around about 150 meter.
what is intrinscily safe system and where we use?
send me last 5 years questions asked in rrb chennai, for section engineer
what is the difference between active & reactive power?
how will you segregate the alarm levels in alarm management system during factory Acceptance Test
Working principle of magnetic flow meter ......and calibration procedure of e+h magnetic flowmeter...
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
how to calibrate mass flow meter (Coriolis)? Example calibration range: 0 to 2500 kg/hr line size 3" fluid: Etheline glycol (MEG)
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
Explain PID controller tuning & any one method used for it.
Whatis the reset ofset and control system in instrumentation
Why the ammonia and Nitric Acid level indicators is with millimeter ? and What is the conversion form millimeters that level indicator indicate to weight ?
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
Instrument QA/Qc what is the project quality plan?conduit inspection RFI. which documents attache with package?
What is loop1 and loop2 in MTS LT?
