Interested to Buy Any Domain ? << Click Here >> for more details...
What happen if a 18 watt fluorescent tube is used on 36watt choke,which one damaged or not damaged, if damaged why that damaged?
- 2 Answers
- 3385 Views
- Bharat ITI, I also Faced
- E-Mail Answers
Answer Posted / pk
the 18 watt fl will work only 18 watt chock nothing will happend
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Tell me about ur past electrical maintanence job
Why PT voltages are measured with respect to ground? What do u mean by voltage or current polarized.
How to Prepare preventive maintenance shedule of machine tool.
what are the differences between 'exhaust fan', 'heavy-duty exhaust fan' & 'super heavy duty exhaust fan'. what are their power ratings ?
15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help
with help of neat sketch explain principle of TIG welding process
What are capacitive,resistive,inductive surge absorbation? What is ferranti surge absorber? What is lagrangian cost? What is Px operator?
What is a differential amplifier? Also, explain cmrr.
if a.c supply is given to the motor,, what happen?
WE know that for Inductor X=2pifL,In DC f=0,then X=0 so,V=IX=0;But In the DC excitation of rotor of AC generator,DC motor field coil which coils are inductor so why does not applying DC voltage short the rotor coil of AC generator and field coil of motor?If it would then DC source might be damaged but it is not happened. Why does the strand conductor of Electrical power transmission line make twist?
Why do we avoid electrical conduits in floors at apartments?
How can ou verify the size of conductor 50Sq.mm ACSR
Why efficiency of generator is higher than motor at a particular load?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
