Interested to Buy Any Domain ? << Click Here >> for more details...
why fault current always calculated for 1 seconds?
- 3 Answers
- 5114 Views
- Coca Cola, I also Faced
- E-Mail Answers
Answer Posted / renish2905
Becuse of the fault current is very large and small time about 1 second or friction of second.in this time CB is activated nearly less than of second.and all about calcualtion to took fault current time 1sec for easy to calculation.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
What are the specifications for conducting earth leakage test as per IEC standard?
what are the possible reaons & remedies if resistance of NGR getting heat up
why normally Generator rating are between 11Kv to 22Kv?
How is the gain affected by the introduction of feedback in a control system.
describe the A.C. Generator Testing procedure
it is possible to rotate the DG engine dc starter with wrong polarity connections? why?
How to calculate the heat load for a electrical room
Is it possible to measure correct value of earth resistance & cable insulation ristance with out disconncting earth lead & both sides of cable ends? If not, any other method to measure ER & CIR with out disconneting from the system.
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases flux A does not alter B decreases C increases D none of above
high voltage transformer input voltage,current and amps rating..distributed transformer input voltage,current and amps rating...
What is gross error?
im working in one private compeny in gujarat. i was complet diploma electric in 2010 from gujarat technical board. now i want electric supervisor licence in gujarat but i dont't know when i apply? plz give me address of the licence dippartment office in gujarat. gandhinagar
critically criticize the application of ring main unit in power system
condition Autotrip facia come on control panel of electrical transmission line?
How will change the frequency in distribution side?
