Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between IS:1554 (Part 1)/1988 &
IS:694/1990 ? What do these two standards specify about?
- 2 Answers
- 21037 Views
- I also Faced
- E-Mail Answers
Answer Posted / rahul tiwari
IS 1554 have Inner in multi cores with Armouring process but in IS 694 there is not an Inner sheath & Armouring .
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
What will be the effect of circulating current in HT xlpe cable when both the armour ends are grounded. Will the termination fils after some time in case of 33 kv supply.
is it possible to start a motor in felid connected to a remote mcc
can i connect wavetrap in 2 different phase in EHV line?
How u can give the overload setting to any motor protection relay for a HT motors with formula and Example?
difference between servo motor and synchronous motor
why motor range is available 22kv,30kv,37kv,45kv and so on? why motor range is not available 21kv,24,25,26,27kv and so on?
How wire size can define in electrical wiring? What is the ratio?
What is the range of the stator resistance of 3 phase induction motor?
What is lifting power for 1 wb/m2 and 1 A magnet?
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
WHY CBCT USE ONLY IN Y PHASE NOT OTHER PHASES
How it can worked plc based electrical system And which type of software using.
how we can calculate the efficiency of a diesel generator ?
which stabilizer is better ? AVR, Servo Stabilizer, Static stabilizer etc & why explain it
How to work definite,over pluxing,revers power,OSR relay
