Answer Posted / michael
Contractors are used to make and break high current circuits basically in industrial motors
| Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
what is difference between 9kv 5ka surge arrester and 9kv 10ka surge arrester.
What do you mean by lighting transformer?
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
how to check ac servo motor
Explain how to determine capacitor tolerance codes?
What was your role in the silicon evaluation/product ramp? What tools did you use?
How to calculate the sag on transmission Lines.
How to calculate energy stored in an inductance?
what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?
Why increase in current leads to increase in conductor temperature?
what is arc flash and what are the hazards involved
how to calculate the capacitor to maintain power factor?
can we use NPT glands in LT panel
For a stable system, where should the poles of a system be in a root loci plot?
Why two phase welding machine is used instead of three phase welding machine.
