which on of the transformer have more core losses and why?
1. Distribution Transformer
2. Power Transformer
- 5 Answers
- 7071 Views
- I also Faced
- E-Mail Answers
Answer Posted / ajay gautam
Distrbution transformer have more core loss because carrying of high power for long distance and due to the high resistance wire used.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Give two basic speed control scheme of dc shunt motor?
A well system is when , no. of bus bar is less or more. Tell me the concept of it.
Either It Possible a dc Motor to Run On Ac Drive [ Ex : ACS 800 , Yaskawa F7 ] If it is Possible How Pls Inform Me dinesh_elect_eng@yahoo.com
what are the parameters plays a major role in Potential transformer Burden calculation??
How can we measure the residual voltage in dc machines?
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB to another Power DB?
What are the material used for resistor?
Advantage of LT panel vs HT panel
what is the transmission loss for electrical supply? specifically a large shopping complex where the grid is half KM away, what will the % of transmission loss? is there any transmission loss for captive unit generation for above set? thanks
Pls mail me utility & Dg related question with answer
why US countries maintains 110v and 60HZ
Please help me regarding my one concern. - During earth pit testing we noticed that the Clean earth pit and dirty earth pit showing continuity (Resistance value - 5ohm) . I want to know that if both earth pit have separate location and there is not internal looping between PIT then why such continuity is showing on it . Because of this issue the field side all earthing point showing short. In PLC panel we are providing two types of earthing cable which is coming from separate earth pit (Clean and Dirty earth pit) because of earth PIT showing short our PLC is not complying spec . please help regarding this issues.
In a flange coupling, the flange bolts are designed for
please describe the Transformer setting, Motor setting, I/C setting, Tie setting
How to decide whether A / B / C / D curve type MCB should be used?
