Interested to Buy Any Domain ? << Click Here >> for more details...
what will happen when a electric bulb is connected between
two phases.it will glow or not
- 18 Answers
- 44779 Views
- I also Faced
- E-Mail Answers
Answer Posted / nithinpattuvam@gmail. com
As there is no neutral there is no current flow. So the bulb will not glow and it will not get fused
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
What is current & voltage ? Voltage perform at any load without current or not?
diff b/w elcb and rccb
draw the block diagram of fire alarm?
hi pal, i am vengatesh from tamilnadu(chidambaram),i have called for the written test for the post of jr executive(ELECTRICAL) of AAI ,I dont know about the question paper pattern,so any kindly help me to face the examination,post me the model question papers and some tips to write my examination to (vengi.annadurai@gmail.com)
WHAT IS THE TOTAL POWER GENERATION IN CHHATTISGARH?
hello friends this is krunal here.. i have applied for he officer train in hpcl electrical stream.. any one who have applied before for electrical stream please help me out.. post ur reply to my mail id: krunal_airforce@yahoo.com.. any tips, old questions for paper or any help will do.. plz help me.. your faithfully, Krunal Darji
how to calculate sizing of NGTR (Transformer rating,Loading resistor value and Current rating of resistor) and what is the X/R ratio. Details : 11kV,Capacitance 1.73532 micro farads,40kA for 1sec.
Which is the oldest hydropower plant in india?
What should be setting for alarm,tripping and cooling fan on for power transformer's oil temp. and winding temp. indicator?
i wasted one year for the job after completed my btech what can i say about 1year time in interview
Brief me about maintenance planning & sheduling of machine tool.
What are hrc fuses and where it is used?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
A low wet bulb temperature indicates
how can you size an automatic voltage regulator?
