Interested to Buy Any Domain ? << Click Here >> for more details...
what is the pump cavitation?
- 2 Answers
- 5200 Views
- IOCL, KCC, Wohr Parking Systems, I also Faced
- E-Mail Answers
Answer Posted / muhammad jehangir afridi
If the suction pressure at the eye of the impeller falls below the vapour pressure of the fluid bei at the ng pumped,the fluid will start to vaporize.
Any vapour bubbles formed by preessure drop at the eye of the impeller are swept along the impeller vanes by the flow of the fluid.when the bubbles enter a region where local pressure is greater than saturation pressure farther out the impeller vane,then the vapour bubbles abruptly collapse..this phenomena is called cavitation...
It creates noise,vibration and damage to many of the components, a loss in the pump efficiency etc..
| Is This Answer Correct ? | 21 Yes | 0 No |
Post New Answer View All Answers
As per api 650 code for new ss tank fabrication,in bottom plate bulge is acceptable? How many bulge acceptable for api 650?
We select 10mm nominal thickness for Elip head of a pressure vesel. The minimum thickness after forming is 8.2mm. (Shell thickness is 8mm. The minimum thickness after forming is satisfied or not with UG-79 (d)(3) in ASME SECTION VIII, Div.1?
what are the points that should be kept in mind during forging design?
What is flash steam and flashing phenomena?
Define monochromatic emissive power. [Ebλ]
We have 6-axis wotan horizontal milling & boring machine. Linear axis- x,y,z,w & U. Rotary table B Axis Z,U & W axis are parallel. Z is tool axis. X is cross slide. We wish to retrofit the machine.Which control I should select & also suggest How many axis simutaneous control for linear & circular interpolation.
In order to increase efficiency and reduce co emissions and other emissions, clear coal technologies are receiving major attention. What are these ?
Which are the sheets of metals?
Explain how the cylinder lubrication on main engine is done?
which fit is this 177-S6?
What are the protections in a Diesel generator Engine?
What are to be checked in an induction motor?
what is fullform of ge 9ea gas turbine
• What is your weakness?
Dear sir-I WANT LAST FIVE YEARS RRB-CHENNAI QUESTION&ANSWER PAPER IN J.ENGG(GRADE:II)-MECHANICAL ENGINEER
