Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / faisal nazar
Total distributer control system (TDC-3000)
Yamataqi /Honeywell
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
what is the difference between active & reactive power?
hye SAM acn u send your e mail id, so that i can solve my query through e mail?
Describe the function of Accumulator into the Pump
can you send remote seal interface level transmitter calculation steps for oil water saperator.
how do u calibrate the vacuum transmitter if it shows more reading
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
you are on site,the plant trips,you are approached by operations,what do you do?
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
what is the calibration procedure for transweigh make weigh feeder?
hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel
what is the procedure of O2 sensor(ABB) calibration?
Gas equation
Hi i m B.E. In elect. & comm. I m workin in bio mass plant from 6 mnths as inst. Engg. but now i m in dept. Of operation as shift engg...which is best operation or inst. 4 me? M confusd..plz help and reply me..
i have done DAE in Instrumentation and Process Control. i have applied for an apprentice training in chemical company after three day my interview will be conduct but i need more information about industrial process control and controller. my e mail is imran_dilsetu@yahoo.com please tell me interview question relative to instrumentation ?
HOW CREATED LP & HP PRESURES IN DRUM FOR DRUM LEVEL MEASUREMENT!
