Interested to Buy Any Domain ? << Click Here >> for more details...
How can step up and step down process in power transformer
- 1 Answers
- 2652 Views
- MSETCL Maharashtra State Electricity Transmission Co Ltd, I also Faced
- E-Mail Answers
Answer Posted / vinoth
Power Transformer Step UP and Step Down Process was Doing,
Basically This process depends upon No of Turns/windings of Primary and Secondary
If Step Up process,The no of turns is high in Secondary then Primary
If Step Down Process The No of turns is less in secondary then primary
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is acceptable leakage current for 33kv cable while doing high voltage test for cable? how to calaulate the leakage current for 33kv or any rated cable?
What is the RMS and DFT principle of analogue maesurments. Which way they are advangages. where which princples give optimum results.
how we can do the insulation on secondary of ct explain and so that tan delta will within limit
what is meant by directional earth fault and non directional earth fault? describe both.
what is stper motor
what is negative d.c. voltage, why this voltage is used in base transciever station.
a governer in an Ic engine controls the
use of choke in APFC panels
Whats the minimum value for I.R. that can be allowed for HT & LT alternators for operation?
How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.
What is minimum permicible value of leackage current for LT Panle when applying voltage up to 3 KV for 5 Minuits?
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
how commomn gate triggering is given for TRIAC ? other thyristor wont be efffected?
Why air circuit breaker off due to power failure?
A ii kv 1200 A Breaker combination fixed in a cubicle. How many ampere Fuse is required? If fuse is not using, Why?
